Kayak and Fishing Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
180 Posts
Discussion Starter · #1 ·
Hello fellow rod builders.

I am trying to visualise how to finish off the winding checks for a SK2 spinning seat. I know there are plastic metal looking winding checks for this reel seat but I don't know if they will look too plasticy, I would rather silver aluminium ones but none are specific for this reel seat. Any ideas from the pro's on this issue?

Cheers
Dan.
 

·
Registered
Joined
·
5,464 Posts
Yakcoosa said:
Thanks for the reply.

I have had a look at the various options, it just seems none would be as good a finish as the fuji ones that click in like leggo. Just worried how a smaller winding check would fit on the ends of the reel seat and be flush with the edges... might just have to order a few and see?
both mudhole and Matagi are good are replying to queries via email
if you tell them what seat you have, they will tell you if your choice provides a snug fit

good luck
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top