Kayak and Fishing Forum banner

P13 fishfinder mount

1004 Views 4 Replies 2 Participants Last post by  Arcachon
I am about to install a Cuda 168 fish finder onto my P13. Interested in any advice on the best mounting point or position. I have purchased a Ram mount which I was intending to set inside the forward drink holder. I would run the transducer cables through the wall of the drink well.

Although the theory sounds fine my concern was the water could sit inside the drink well and I would have to make double sure about sealing any holes.

Anyone got any experience with this?
1 - 1 of 5 Posts
Providing you make your cable penetrations into the hull at a height greater than the drainage lip of the cupholder and are generous with the sealant, then there should be no problems I can forsee.

1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.