Kayak and Fishing Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
473 Posts
Discussion Starter · #1 ·
The Hobie cart have 4 welded joint on horizontal kayak support bar & wheel axial. My cart have been torturing by fishing gears load and bumpy ride. All 4 welded joint are broken. I don't know how to weld, so I have to find a solution which can keep it my old cart going. Basically, the cart can hold up as soon as it plugs into scrubber holes. If both vertical bar can run freely, the horizontal kayak support bar may break free. Therefore I need to stabilize it. I went to hardware store to buy 4x 11-16mm stainless steel 316 hose clamps. It is rust prove and only cost me 2 dollar each. Perhaps, it can be done by 2 clamps. Anyway, I am happy to spend $8!
 

Attachments

·
Registered
Joined
·
12,307 Posts
A terrific solution mate, well done
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top