DIY General • Fitting transducer on a Viking Nemo

DIY Stuff that doesn't fit anywhere else

Fitting transducer on a Viking Nemo

Postby Toffeeboy » Fri Mar 25, 2016 12:11 pm

Hey All,
Just after a few tips / photos how to fit a transducer in the hull of my nemo. I was about to glue some foam to the hull, with a cut out for the transducer to be sealed in. I feel that the hull is not completely flat and was worried about losing the effectiveness of the transducer. Any suggestions or photos would be great, thanks in advance. Toffeeboy
New Member
Posts: 6
Joined: Thu May 23, 2013 8:21 pm
Location: Albany Creek
Kayak: Viking Nemo

Return to DIY General

Who is online

Users browsing this forum: No registered users and 3 guests